MU100HxxxAQ_MB series is a 60W explosion-proof LED driver suitable for Zone1 and Zone2. Existing explosion-proof lamps are explosion-proof certified with a housing protection. This requires high sealing strength of the lamp housing, which increases the difficulty of the design, and increases the size and weight of the housing. Affects housing cost, transportation costs and difficulty of installing lamps. And 100% test sealing strength is required during the production of lamps, which greatly affects the production cost and yield. MU100HxxxAQ_MB has obtained "ExⅡ2G Ex mbⅡC Gb" explosion-proof certification, which greatly reduces the difficulty of designing the lamp housing and the above problems.
High Surge Immunity
MOONS' have developed a range of LED drivers subject to IEC 61000-4-5, that is a test for electrical and electronic equipment with regard to unidirectional surges caused by over-voltages from switching and lightning transients. With L/N 4KV L/N-FG 6kV surge level, the MOONS' LED drivers are reliable to protect your lamps against surges.
Dimming Function Introduction
MU100HxxxAQ_MB is a programmable driver, all driver's parameters can be modified through MSSL200(The Programmer of CLKS or CP Series driver ),Such as output current value, start time, fade up time, selecting dimming mode (include modifying parameters in corresponding mode) and so on, which can meet other special and customized requirement, such as 100W/1000mA、100W/2000mA、100W/3000mA and so on. What’s more, the driver is compatible with charged or uncharged programming mode.
MSSL200 is the programmer of CLKS or CP Series driver.The Programmable Driver Configurator Software and Configurator are compatible with MOONS’ CLKS and CP drivers. They can be used to set the configuration parameters of MOONS’ CLKS and CP drivers.
2. Dimming Function-Constant Power
Output Current: 65%～100% ×rated output current This series driver could achieve rated output power while adjusting output current range at 65%-100% rated output current.
Note：output current setting range with constant power 65%～100% Iomax
3. Dimming Function-PWM/1-10V Dimming
Allow users to set the max and min output current and corresponding outputvoltage to clarify the 1-10V dimming curve. Input a 0~10V signal from 2ndpin of the dimming interface. Default: input ≤1V, output current 10%; input≥8.5V, output current 100%; input≤0.5V, Dimming off; input ≥0.8V,Dimming on.
Input a PWM signal from the 2nd pin(Dim+/Program) of thedimming interface to change the output current.User can set "Positive Logic" or "Negative Logic" of the PWM signal.PWM duty circle: 10%~99%(it has both positive andnegative logics ), frequency: 500Hz~5kHz, 3V~10V is high,-0.3V~0.8V is low. Default: PWM≤5%, Dimming off; PWM≥8%, Dimming on.
4. Dimming Function-Smart Midnight ClockDIM
Smart Midnight ClockDIM has self-study Clock Dimming function. It can set 5 dimming level in the dimming plan through software. It also can adjust the starting time and ending time in the dimming plan everyday automatically according to the geographic position and average operating time. In other words, the CP series driver can adapt to the changeable starting and ending time due to the seasonal alteration by self-study function.
5. Dimming Function-Fixed ClockDIM
Users can set the dimming plan by separating 24hours into 5 sections matching corresponding output current. Owing to the time is fixed, it has no self-study function. For instance: Assuming the dimming plan like below table shows. If the driver is charged at 15:00pm, the driver will perform the dimming plan following the form shows.