Skip to content Skip to navigation menu

Software

All available software downloads allow you to set up, configure, test and control MOONS' high performance motion products.

SCL Library

Description:Serial Port communication with SCL language

Read More

CANopen Library

Description:CANopen communication library

Read More

M Servo Suite

Application:M2 Servo Motor
Description: M2 servo system can accomplish real time response to the dynamic feedback of the load and optimize gain tuning parameters on-line automatically.

Read More

Step-Servo Quick Tuner

Application:SS、SSM、TSM、TXM、RS
Description: Step-Servo Quick Tuner is the PC based software application used to configure, and perform servo tuning, drive testing and evaluation of the Step-Servo.

Read More

ST Configurator

Application:ST、STAC、STM、SWM
Description:The ST Configurator software makes setting up, configuring and programming ST, STAC and STM stepper drives a snap.

Read More

Q Programmer

Application:ST,STB,STAC
Description: Q Programmer is a single-axis motion control software for programmable stepper and servo drives from MOONS’. The software allows users to create sophisticated and functional......

Read More

STB Configurator

Application:STB
Description:The Step-Servo Quick Tuner is a PC based software application to configure, drive testing and evaluation of the STB product.

Read More

CANopen Test Tool

Application:ST、STB、STAC、STM、SWM、SS、SSM、TSM、TXM、SV、SVAC、M2
Description: Testing CANopen communication,it helps you to develop and analysis your CANopen …

Read More

RS485 Bus Utility

Application:ST、STB、STAC、STM、SWM、SS、SSM、TSM、TXM、SV、SVAC、BLD、M2
Description: The RS485 Bus Utility is an easy and powerful terminal to setup and test a multi-axis network via MOONS' SCL …

Read More

SV Quick Tuner

Application:SV、SVAC
Description: For configuration of SV7 DC servo drives.

Read More

Inertia Conversion Factors

For example:Electronic rotor inertia is 90 g-cm 2,convert to oz-in-s 2
according to the table above, conversion ratio1.416 X 10 -5
the new inertia value is =90 X 1.416 X 10 -5=1.27 X 10 -3zo-in-sec-2

Torque Conversion Factors

For example:motor torque is 53oz.in,covert to kg.cm
according to the tabe above, conversion ratio is 7.201 X 10 -2
then the new inertia value is=53 X 7.201 X 10 -2=3.816kg.cm